4 bearing shaft support 1" vertical - Gable drive - PU = 20 pcs
Product information "4 bearing shaft support 1" vertical - Gable drive - PU = 20 pcs"
Our vertical bearing shaft supports 1" allows to set the drive shaft as close as possible to the gable end. In such a construction the shading screens do not set against the truss , but lay either over( in suspended system) or below ( in lay- flat system) the square tube, covering the whole area up to the gable end. The dalay of screens is basically not needed.
The drive shaft can easily and quickly be pre-assembled on the ground. So dangerous, time-consuming works underneath the roof can be avoided.
The bearings are attached onto the square tubes and locked with locking screws. If needed, they can be moved
The drive shaft can easily and quickly be pre-assembled on the ground. So dangerous, time-consuming works underneath the roof can be avoided.
The bearings are attached onto the square tubes and locked with locking screws. If needed, they can be moved
Einbaubeispiel
Customers who viewed this item also viewed:
Steel tube galv. narrowed, 1'' / 2,5mm - L= 6,50 m - Bundle = 81pcs
PU: Bunch
This steel tube is used as a drive shaft for ventilation systems and large shading systems in greenhouses.Due to its wall-thickness of 2,50 mm, it is resistant against torsion.The tubes can be easily connected by inserting them into each other through their swaged ends and bolting them afterwards. Bolt M8 x 50 with a nyloc nut M8 are neededDiameter: 1 Wall thickness: 2.5 mmLength: 6500 mmMaterial: Galvanised Steel
Login for price display
Support plate Fiberlane 1" - Height: 100 mm - Lower edge to middle of drive shaft 62 mm
Height (mm): 100
This high quality support plate from TGU works as a bearing for 42 mm drive shafts in ventilation systems in greenhouses. It has straight mounting holes. This support plate is especially durable even under heavy weights thanks to a slide bearing, which is fitted with a special plastic ring. This bearing offers perfect slide effects and works as a substitute for grease. Material: Galvanized steelMounting height: Lower edge to middle of drive shaft 62mm
Login for price display
Slide bearing plate B1" Straight - B1\B062\L092
Length: B062\L092 | Version: Straight
The support plate works as a bearing for 34 mm drive shafts in greenhouses. It is equipped with straight mounting holes. Thanks to built -in slide bearing, which is constructed with a centred bronze ring, this support plate is very durable and suitable for applications under heavy weights. In addition this slide bearing functions as a substitute for grease. Material: Galvanized steelMounting height: Lower edge to middle of drive shaft 62 mmRidder Art.-Nr.: 503086
Login for price display
Steel tube, galvanized 1"
PU: loose
This steel tube is used as a drive shaft in shading and ventilation systems in large greenhouses. Due to its wall thickness of 3.25 mm, it is very resistant against torsion. The tube connector halves within our product range are used to connect the tubes. Diameter: 33.5 mm Wall thickness: 3,25 mm Length: 6050 mm Material: Steel, galvanized
Login for price display
Steel tube galvanized, narrowed, 1'' / 2,5mm / L= 6,50 m
PU: loose
This steel tube is used as a drive shaft for ventilation systems and large shading systems in greenhouses.Due to its wall-thickness of 2,50 mm, it is resistant against torsion.The tubes can be easily connected by inserting them into each other through their swaged ends and bolting them afterwards. Bolt M8 x 50 with a nyloc nut M8 are neededDiameter: 1 Wall thickness: 2.5 mmLength: 6500 mmMaterial: Galvanised Steel
Login for price display