The wire guide protects the poly wire in lay-flat energy screens from friction, caused by the screen profile. In suspended systems it works as a connection between support wire and screen profile. The wire guide is installed into the screw channel and can slide sideways within it.Material: plastic

These all-purpose T-bolts combined with an M6 nut are the perfect solution for bolting the slip joint to screen profiles in shading and ventilation systems. Material: Stainless steel

These all-purpose T-bolts combined with an M6 nut are the perfect solution for bolting the slip joint to screen profiles in shading and ventilation systems. Material: Stainless steel

The rubber seal closes the space in-between screen profile and truss. This prevents direct penetration of sunrays into greenhouse as well as unnecessary heat losses, when the energy screens are closed.This rubber seal is easy and quick to install on screen profiles Type I-V. Material: rubber

The 90° angle connector strip can be used to connect all kinds of screen profiles for shading screen to be hung down sidewards. It is available including the bolts and pre-cut screw-thread.

The connector strip 135 can be used to connect all kinds of screen profiles. It comes including the bolts and pre-cut screw-thread. Material: aluminium

These all-purpose T-bolts combined with an M6 nut are the perfect solution for bolting the slip joint to screen profiles in shading and ventilation systems. Material: Stainless steel

Our professional cable clamp provides a strong connection from the drive wire to the screen profile in the shading system. The wire is firmly fixed into the cable clamp upon mounting.Material: aluminium

The retainer clip is used as a protective element for cloth overhangs in lay flat shadings systems. Clip profile goes through it without touching the cloth. The retainer can quickly and easily be inserted and screwed into the channel of the screen profile.

This tube insert is used to assemble roll-up tubes from galvanized 50 mm precision tubes EN 10305-3 with a wall thickness of 2 mm. It is inserted into the tubes and is working as a centric bearing inside of them.The tube insert has the bearing 626 zz with extended inner ring . Therefore there is no need to use a spacer. Material: Steel galvanized