Steel tube galv. narrowed, 1'' / 2,5mm - L= 6,50 m - Bundle = 81pcs

This grooved cable drum ensures friction free, well-ordered winding and therefore a smooth movement of driving cable in shading systems .Two-halves model of the drum makes it possible to fasten it onto drive shaft subsequently. The two halves are connected quick and easy with a hose clamp and then installed onto the drive shaft with a headless screw.The cable drum is made of high-impact resistant plastic, that is friendly to cables and therefore increases their durability. Can be used with cords with a diameter up to 3 mm For 34 mm drive shaftsCapacity of cable drum: up to 5,70 m

This grooved cable drum ensures friction free, well-ordered winding and therefore a smooth movement of driving cable in shading systems .Two-halves model of the drum makes it possible to fasten it onto drive shaft subsequently. The two halves are connected quick and easy with U-bolt. To install the drum onto the drive shaft a headless screw is needed.The cable drum is made of high-impact resistant plastic, that is friendly to cables and therefore increases their durability. Can be used with cords with a diameter up to 3 mm For 34 mm drive shaftsCapacity of cable drum: up to 5,70 mMaterial: Cable drum: High impact resistant plasticU-Bolt: Galvanized steel

This offset bearing has been developed for suspended shading systems with gable end drive. It brings the drive shaft to an optimal position and as a support point enables its rotation. The product has been built to hold trailing load. Material: High impact reistant plastic For mounting you will need the following parts: - M 8 x 70 bolt - M8 nyloc nut

Our vertical bearing shaft supports 1" allows to set the drive shaft as close as possible to the gable end. In such a construction the shading screens do not set against the truss , but lay either over( in suspended system) or below ( in lay- flat system) the square tube, covering the whole area up to the gable end. The dalay of screens is basically not needed.The drive shaft can easily and quickly be pre-assembled on the ground. So dangerous, time-consuming works underneath the roof can be avoided.The bearings are attached onto the square tubes and locked with locking screws. If needed, they can be moved

This high quality support plate from TGU works as a bearing for 42 mm drive shafts in ventilation systems in greenhouses. It has straight mounting holes. This support plate is especially durable even under heavy weights thanks to a slide bearing, which is fitted with a special plastic ring. This bearing offers perfect slide effects and works as a substitute for grease. Material: Galvanized steelMounting height: Lower edge to middle of drive shaft 62mm