Cable drum 1" - Typ II for tube 33,4 mm - Motion range 570 cm - PU = 12 pcs
Product information "Cable drum 1" - Typ II for tube 33,4 mm - Motion range 570 cm - PU = 12 pcs"
This grooved cable drum ensures friction free, well-ordered winding and therefore a smooth movement of driving cable in shading systems .
Two-halves model of the drum makes it possible to fasten it onto drive shaft subsequently. The two halves are connected with four screws included intothe set. To install the drum onto the drive shaft a special headless screw is needed.
The cable drum is made of high-impact resistant plastic, that is friendly to cables and therefore increases their durability.
Can be used with cords with a diameter up to 3 mm
For 34 mm drive shafts
Capacity of cable drum: up to 5,70 m
Material:
Cable drum: impact resistant plastic
Two-halves model of the drum makes it possible to fasten it onto drive shaft subsequently. The two halves are connected with four screws included intothe set. To install the drum onto the drive shaft a special headless screw is needed.
The cable drum is made of high-impact resistant plastic, that is friendly to cables and therefore increases their durability.
Can be used with cords with a diameter up to 3 mm
For 34 mm drive shafts
Capacity of cable drum: up to 5,70 m
Material:
Cable drum: impact resistant plastic
Einbaubeispiel:
Customers who viewed this item also viewed:
Cable clamp
Size (mm): Ø 3
Is used for the attachement of 2 mm aircraft wire. Material: Steel Galvanized
Login for price display
Aircarft cable galvanized 7x7 3 mm x 100 m
Length (m): 100
A durable aircraft cable for shading systems.Material: Steel Galvanized
Login for price display
aircraft cable INOX 7x7
Length (m): 1000
A durable, stainless aircraft cable for cable drive shadings systems. Thanks to these characteristics it specially fits external constructions. It is compatible with our slip joint. Tensile strength:Material: Stainless Steel
Login for price display
Offset bearing 1" - 50/50 - PU = 25 pcs
PU (Pcs): 25
This offset bearing has been developed for suspended shading systems with gable end drive. It brings the drive shaft to an optimal position and as a support point enables its rotation. The product has been built to hold trailing load. Material: High impact reistant plastic For mounting you will need the following parts: - M 8 x 70 bolt - M8 nyloc nut
Login for price display
4 bearing shaft support 1" vertical - Gable drive - PU = 20 pcs
PU (Pcs): 20
Our vertical bearing shaft supports 1" allows to set the drive shaft as close as possible to the gable end. In such a construction the shading screens do not set against the truss , but lay either over( in suspended system) or below ( in lay- flat system) the square tube, covering the whole area up to the gable end. The dalay of screens is basically not needed.The drive shaft can easily and quickly be pre-assembled on the ground. So dangerous, time-consuming works underneath the roof can be avoided.The bearings are attached onto the square tubes and locked with locking screws. If needed, they can be moved
Login for price display
Tube connectors halfs 1" - incl. 4 bolts M8 x 45 - PU = 25 Sets
PU: 25
These tube connector halves are used for reliable connection of 34 mm steel tubes for drive shafts. Compared to heat-welded connection our tube connector halves offer higher stability and durability. The connector halves are bolted to the steel tubes with the included M8x50 bolts. Material: Steel, galvanized
Login for price display